top of page

BLOGUE LA BULLE

How to use and take care of your 3D Molds and Accessories

Updated: May 29, 2022


The material used for the manufacture of molds and accessories is a polymer

of plant origin and biodegradable.

How to use:



  • Bath bombs:

Assemble the base and the sleeve part. Fill with product and press flat on a table.


Unmold by sliding the sleeve out. Tap with the back of a spoon to dislodge the bath bomb from the surface.


Let dry outside of the mold.




  • Shampoos:

It is recommended to cover both sides with plastic wrap before use.


Assemble the base and thesleeve, fill with product and press flat on a table. Unmold by sliding sleeve out.


Let dry outside of the mold.




Care and clean:


Easy to clean, rinse with cold water only and wipe dry immediately with a dry cloth.

Do not soak in water.


Do not wash in the dishwasher, use hot water or detergents.


Store in a dry place, away from heat and humidity.


How to use:

Use your stamp on your soaps after saponification, depending on the recipe and the consistency of the soap between 24 and 36 hours after cutting.


You can cover with plastic wrap before pressing.


It is not necessary to fully press the stamp into the soap, experiment to see when is the best time to stamp according to your recipe and cure.


These stamps work as much with soap made by saponification as with melt and pour bases.


Care and clean :


After using your stamp, you can use a nail brush to clean it.

Rinse it under cold water only and wipe it off immediately with a dry cloth.


Do not soak in water.


Do not wash in the dishwasher, use hot water or detergents.


Store in a dry place, away from heat and humidity.


How to ues:


It is recommended to cover your mold with plastic wrap before pressing the dough inside.


The chemical reaction with saponification as well as heat should be avoided.


* Note that these molds have also been tested with cold soap bases and 70 ℃ (160 ℉) glycerin by spraying alcohol before pouring.


Results: The molds are not affected but d

unmolding is not easy without the plastic wrap.



Care and clean:


Easy to clean, rinse with cold water only and wipe dry immediately with a dry cloth. Do not soak in water.


Do not wash in the dishwasher, use hot water or detergents.


Store in a dry place, away from heat and humidity.

bottom of page