Bath Bomb Mold - Popsicle with Bite
This bath bomb mold made of PLA* is 3D printed on order.
This mold is made in 3 parts and is used as a hand press.
 
Dimensions of the mold: 5 cm x 9 cm x 3.5 high
 
The colour of the mold may be different from the picture.
 
* PLA material (Polylactic acid) is a polymer material made from vegetal origin.

Bath Bomb Mold - Popsicle with Bite

C$25.00Price

  • Bath bombs:

    Assemble the base and the sleeve. Fill with product and press with the insertion, flat on a table. Unmould by sliding the sleeve out and tap with the back of a spoon to dislodge the bath bomb from the surface. Dry outside the mold.

     

    Shampoos:

    It is recommended to cover both sides with plastic wrap before using or spray with a silicone solution (Cyclomethicone).

    Assemble the base and the sleeve. Fill with product and press with the insertion, flat on a table. Unmould by sliding the sleeve out. Dry outside the mold.

  • Easy to clean, rinse with cold water and wipe dry with a dry cloth. Do not wash in the dishwasher or use detergents. This material is not chemical or heat resistant.