This bath bomb mold made of PLA* is 3D printed on order.
This mold is made in 4 parts and is used as a hand press.
The icing insert is the same diameter and can be combined to replace the straight insert.
You can make with the 5 parts, three different models either a complete cone with the galcage in one piece, a glaze, or a cone only.
Frosting alone is also offered independently with a shorter sleeve.
Dimensions of the mold: 6 cm diameter x 8 cm height.
The colour of the mold may be different from the picture.
* PLA material (Polylactic acid) is a polymer material made from vegetal origin.
Bath Bomb Mold - Ice Cream Cone
Assemble the base and the sleeve. Fill with product and press with the insertion, flat on a table. Unmould by sliding the sleeve out and tap with the back of a spoon to dislodge the bath bomb from the surface. Dry outside the mold.
It is recommended to cover both sides with plastic wrap before using or spray with a silicone solution (Cyclomethicone).
Assemble the base and the sleeve. Fill with product and press with the insertion, flat on a table. Unmould by sliding the sleeve out. Dry outside the mold.
Easy to clean, rinse with cold water and wipe dry with a dry cloth. Do not wash in the dishwasher or use detergents. This material is not resistant to heat or chemicals.